Beaded Pig Pattern

Welcome to the 3-D beaded Pig pattern instructions! If you have any difficulty following this tutorial, please post a comment at the bottom of the page on which you are stuck, and I'll do my best to help!

Step 1

Step 1 : Cross at your newest bead, number 7. Now your almost done with your pigs nose!

Step 2

Step 2 : This is a picture to show what you should have so far.

Step 3

Step 3 : Bring your red thread through existing bead numbers 19, 20, and 1. On your black thread, add bead number 8! This will be the last part of your pigs nose.

Step 4

Step 4 : Cross at bead number 8 and pull tight. Your done with your pigs nose, yay!

Step 5

Step 5 : This is the pigs face! Your pig should look like this.

Add a Comment (No sign-up, just post)
Name
Comment
Verification	Reload Image	Enter the code here:
Beader Comments:
Allegra on December 14, 2008:
Hi Meg, it's hard to say what went wrong without seeing your pig. What I can suggest is to undo the last few steps (ie, undo the snout) and then try it again from scratch by more carefully following the diagrams. I often screw up and then have to go back and fix it. So don't worry about it! If you still can't get it, post a picture on the forum of your pig and I'll try to "diagnose" the problem. Hope that helps!^^
Meg on December 9, 2008:
I don't know what i'm doing wrong but how come the snout of the pig look out of place(its look like a bunch of beads stuck together)... what i mean it that the front of the snout it not lined up like urs.... advise plsss.
Add a Comment