Beaded Diamond-Shaped Ring Pattern by Allegra

Welcome to the beaded diamond-shaped ring pattern instructions! If you have any difficulty following this tutorial, please post a comment at the bottom of the page on which you are stuck, and I'll do my best to help!

Step 36

Step 36:This is just a picture to show you how long I made mine. I had 5 repeating units. My fingers are fairly average in width.

Step 37

Step 37:Here I am showing you how to fit the ring to your finger to see if it's the right length. Just tie a knot after crossing the last green seed bead you added to secure it.

Step 38

Step 38:Now fit it around your desired finger. Remember that different fingers have different widths so pick which finger you imagine wearing it on. I wear it on my ring finger because it's dainty. In the picture, I am showing you what it would look like if the ring was too long. You should not have any extra slack like that (any overlap) or the ring will not sit, but rather it will turn on your finger or slip off. The right length means the two ends will just barely be touching.

Step 39

Step 39:Once fitted to the right size, pull off the last green seed bead you added (I used a needle to help me pry it off). This is because you will be connecting those white bugle beads to the green seed bead on the other corner of the base of your ring instead.

Step 40

Step 40:Here I show you how to cross the green seed bead on the opposite corner of the ring of your base with the ends of the fishing line coming out of your last set of white bugle beads. This will close the loop of your ring seamlessly! No one will ever know how the ring began or where it ended!

Add a Comment (No sign-up, just post)
Name
Comment
Verification	Reload Image	Enter the code here:
Beader Comments:
There are currently no comments for this page. Add your comment today!
Add a Comment